PDA

View Full Version : Portable Winch Mounting Electrical



dsieker
03-26-2011, 05:40 PM
hey guys, my plan is to mount my winch so it can be transferred from front to back via the 2" receiver. I have all the hardware mounting plate 4500lbs winch etc. The only issue i have is how to run the electrical leads and stuff i am completely clueless when it comes to anything electrical i would like some advice on how someone else has done this. the idea would be just to have a quick connect at each end of the machine but i have zero idea on how to make that happen.

bradley s.
03-28-2011, 09:33 AM
It's really simple actually cuz the solenoid mounts under the hood n u just run all the wires n tie strap them out of the way of everything

purplewg
03-28-2011, 01:48 PM
You can route the wiring front and back and put a quick disconnect on these. The winch will have the mating connector that just plugs in. Here is a good place for those supplies for very reasonable prices. http://www.easternmarine.com/Trailer-Winch-Parts-Accessories/