eemueller
03-05-2012, 05:56 PM
Hello all. New member, Eric, here.
I've had my 6x4 gas gator for several years, and never had any problems until just the other day. I was hauling a load to my burn pit, and the engine just quit. It has the FD620D engine. Before dying, it did run roughly for just a few seconds, like it was only firing on 1 cylinder. It cranks fine and the plugs spark, but no start. I followed the diagnostic chart in the tech manual, and I'm getting the correct voltages, but I'm unable to check the ignition control box since I don't have a test light. I did notice that the voltage on the pulser coils (next to the flywheel) was fine (.5 VAC), but there was 0 ohms resistance. The manual was looking for between 85-235 ohms.
I cleaned the carb and checked to see that fuel was coming out of the spark plug holes when I cranked the engine, and it is. Even using starter fluid, I can't get a cough out of this motor. I'm stumped.
Before I bite the bullet and haul it into the local Deere dealer, I was hoping maybe someone on the forum might have a suggestion. Thanks in advance.
I've had my 6x4 gas gator for several years, and never had any problems until just the other day. I was hauling a load to my burn pit, and the engine just quit. It has the FD620D engine. Before dying, it did run roughly for just a few seconds, like it was only firing on 1 cylinder. It cranks fine and the plugs spark, but no start. I followed the diagnostic chart in the tech manual, and I'm getting the correct voltages, but I'm unable to check the ignition control box since I don't have a test light. I did notice that the voltage on the pulser coils (next to the flywheel) was fine (.5 VAC), but there was 0 ohms resistance. The manual was looking for between 85-235 ohms.
I cleaned the carb and checked to see that fuel was coming out of the spark plug holes when I cranked the engine, and it is. Even using starter fluid, I can't get a cough out of this motor. I'm stumped.
Before I bite the bullet and haul it into the local Deere dealer, I was hoping maybe someone on the forum might have a suggestion. Thanks in advance.