550 "Ridge Runner" - Nerf Bars

[mountaingoat]

Hi All. Pictured are some Nerf Bars I built for the "Ridge Runner". They are mounted slightly higher than the frame rails, yet a bit lower than the threshold so as to clear doors. They are angled wider to the rear to easly deflect debris past the rear tires. They are quite sturdy, and provide excellant jack points. The hardware is stainless from the on-line vendor The Nutty Company. Powder coating was done at R & B Powder Coaters of Poultney Vermont. mountaingoat.1300130113021303

[Skillet23]

Very nice. Good looking install. Did you fabricate them also or were they fabricated from The Nutty Company?

David in TX

[mountaingoat]

Thanks David, I designed, built and installed them. "The Nutty Company" is an on-line hardware (nuts & bolts) vendor. When I build an Item I always try to mention sources, and prices should others decide to build one. mountaingoat.