Pulling with the 825i

[DIXIEDOG]

Anybody here pull much with their 825i? I just used my DR power grader with my 825i and the rpms to speed ratio got me a bit concerned, rpms were 4k but speed was only 3mph....is that normal for 825i's?


With my RTV 500 pullling the same grader it never seemed to be much of a load, it's only a 48" wide grader.:hdscrh:

[skidrowe]

Hi DIXIEDOG
I have used my 825i to pull my DR power grader sever times. Honestly I don't remember the RPM range, it's been a couple of months since the last time that used it. But I do know that I had to keep it in low just to be able to keep a semi constant speed of around 3 -4 mph. I did not notice any issues with pulling it, other than that thing is hard to see back there! I am planning on doing some grading this coming up weekend (battery was dead this weekend) and I'll let you know my findings.

I do have the 60 inch model, but doubt that will make much difference.