Update on RSX

[825joe]

Well, I have a 150 miles on her now and still running like a bear. I recieved the letter from JD saying the factory installed oil filter can leak but had already replaced it so didn't have to worry. I have tested the 4wd and diff lock in different trail situations and can honestly say this is my favorite utv. The skid plate has held up quite well and have had to slide over some fallen trees covered in snow which was fun. The only thing I would change is the bed pins are a bit noisy without a load. If they had some rubber isolators on them I think that would take care of it. I think I am going to try and put some rubber tubing over them so the don't rattle. :Thmup:

[WOEII]

Sweet. Mine is all fixed also. :Thmup:

Now I just got to wait till it warms up some. The temps lately are 11f out and I don't want to freeze to death. :Wlys:

[825joe]

My half windshied directs the air over my head pretty good suprisingly.

[tenere67]

I been trying to fix the noisy bed, Haven't had any luck yet.

[jayjay145]

Well, I have a 300 miles on her now and still running like a bear. I recieved the letter from JD saying the factory installed oil filter can leak but had already replaced it so didn't have to worry. I have tested the 4wd and diff lock in different trail situations and can honestly say this is my favorite utv. The skid plate has held up quite well and have had to slide over some fallen trees covered in snow which was fun. The only thing I would change is the bed pins are a bit noisy without a load. If they had some rubber isolators on them I think that would take care of it. I think I am going to try and put some rubber tubing over them so the don't rattle. :Thmup:


Don't know if you saw it or not, but the bed latch pin brackets are adjustable. Look at the bracket that the pins are attached to, there is M8 fastener that can be loosened, and then the bracket will move up or down to adjust the pins. So If the bed is rattling, just adjust the pin bracket down a little, tighten the fastener, and latch the bed. Do each side equal, and go just a little at a time till you get it snug!
Hope this helps!

[825joe]

Thanks bud. Good info.:Thmup: