PDA

View Full Version : RSX 850i In water / underwater?



me203
03-21-2013, 02:16 PM
Compared to the 825i, how does the 850i handle water?
Is it correct that the cvt intake and exhaust, plus air intake all route behind the seat?
If so, does this make it easier to snorkel and make more water capable or is it still and issue to bury the motor in water for a bit like I've heard its bad for on the 825i? Thanks

825joe
03-21-2013, 03:04 PM
a lot better lol. The air inlet and cvt is behind the seats and up high. :Thmup:

825joe
03-21-2013, 03:05 PM
They make a great snorkel for it too at snorkelyouratv.com

me203
03-23-2013, 02:13 PM
I know i"ve read on here that with the 825i, even if you snorkelled the air intake and cvt inlet/outlet, you still shouldn't put it under water because of the alternator and electronics. Is this different with the 850i? I know with my 825i, I got the clutches wet and was stuck in a ditch, along with now the belts and starter squeal all the time at idle, but most loudly at start up.

number3shot
03-23-2013, 06:32 PM
I know i"ve read on here that with the 825i, even if you snorkelled the air intake and cvt inlet/outlet, you still shouldn't put it under water because of the alternator and electronics. Is this different with the 850i? I know with my 825i, I got the clutches wet and was stuck in a ditch, along with now the belts and starter squeal all the time at idle, but most loudly at start up.

How deep was the water you think caused your problems?

825joe
03-24-2013, 01:15 PM
the 850I doesn't have a traditional alternator like the 825i. the 825i is like a car motor and the 850i is a motorcycle style setup. everything is self contained and sealed for the most part.

Growbig306
06-04-2013, 12:34 AM
I can assure you it can't handle this
2386
:Nnd:

GATORDONE
06-04-2013, 11:09 AM
I can assure you it can't handle this
2386
:Nnd:
Looks like yours needs to be equipped with a sump pump! :lol:

WOEII
06-04-2013, 02:08 PM
I can assure you it can't handle this
2386
:Nnd:
Details! :Wlys:
:lurk:

missouri gator
06-04-2013, 03:48 PM
I can assure you it can't handle this
2386
:Nnd:


Growbig, Did ya catch any fish?

Growbig306
06-05-2013, 01:36 AM
HaHa........, and details are very POOR judgement on my part.
2387

Pull plugs, on sixth oil change(likely need a couple more) and third cvt change(again likely need a couple more. Had to take clutch cover off and clean and dry to get it driving today.It's got the service light on(timing is messed up I think). Trailer it in to Deere tomorrow if I have a chance.

It's been a glorious first 11 miles for my new gator!. Good thing my old prowler was there to pull me out and home.:Bnghd:

825joe
06-05-2013, 01:04 PM
damn.....:hsu:

harleydog
06-28-2013, 11:47 AM
did u find out what was wrong with it the same think happened to me it is in the shop for two weeks and they dont no whet is going on with ti

Growbig306
06-30-2013, 12:07 PM
@ harleydog. They replaced ECM, apparently it had water in it. It's located beside the throttle body. Considering its location I'm a little worried about it being a common problem. Initially the were looking at a coil pack because another machine had come in with similar symptoms and that's what it was. Good luck.

harleydog
06-30-2013, 08:17 PM
thanks