825i Floor Mat Part Number

[Catchad81]

Can someone tell me the correct part number for the floor mats in a 2013 825I? Either VGB10132 or BM24282?

Thanks!

[Bunky]

According to JD Parts catalog, it is BM24282.

http://jdpc.deere.com/pimages/0001/0001502002____________A1.gif

[Catchad81]

According to JD Parts catalog, it is BM24282.

http://jdpc.deere.com/pimages/0001/0001502002____________A1.gif

Thank you.

[nakdboardr]

I ordered VGB10132 and they fit fine.:OhNoes:

[campoman]

you can buy diamond pattern black mat on line or a lot of the hardware store carry it ,make a pattern out of card board and cut to fit at half the price

[BillT]

That's what I did, campoman. Found a 4 x 6 x 3/4 inch rubber stall mat (https://www.tractorsupply.com/tsc/product/rubber-mat-black-4-ft-x-6-ft?cm_vc=-10005) at Tractor Supply Co. & cut it to fit for the cargo bed. Just be aware that a reviewer at Tractor Supply says 1) these are 96 pounds in weight before cutting it up & still heavy afterwards
2) there is a substantial rubber smell to them for a while too.

If you have a TSC near you, they're $39.99 each, better than the JD price of $120 for much thinner mat. Oh & remember to pull this out every once in a while so any water can be removed from under the mat.

There's a 4 x 3 x 1/2 inch version (https://www.tractorsupply.com/tsc/product/utility-rubber-mat-black-4-ft-x-3-ft?cm_vc=IOPDP1) for $25, too.

Also check out http://www.ipsrubber.com for mat ideas & bulk purchasing